Steps & Items Needed To Re-Glue A Laminate Countertop
One of the drawbacks of laminate countertops is that it can easily become warped, damaged, and loose over a period of time after being revealed to water, heat, as well as pressure in daily use. When the bendy top splits up from the lower surface, you may be persuaded to replace the entire countertop. However, the damage can mostly be repaired easily by even a beginner to home repairs. Before starting the process, you first need to collect the certain items required for the process & then go through the steps carefully:
Items Needed
- Thin Towel & Iron
- Flat Screwdriver Or Butter Knife
- Cotton Swab, Such As A Q-Tip, Or Cotton Ball
- Acetone & Small Paint Brush
- Contact Cement & Thick Towel
- Weight, Such As Cinderblock Or Heavy bBooks
Steps
- Position a thin towel like a dishcloth on the surface of the area that requires to be re-glued. Make the iron warm and move it delicately over the towel in order to heat the old glue. The towel preserves the laminate from being damaged by the iron, the heated iron will permit the laminate to position up further in order to make the cleaning process accurate.
- Now, squeeze a flat screwdriver or butter knife underneath the unfasten laminate to build a larger space if it is not on the end of the countertop. Sweep it smoothly in order to get rid of any loose glue.
- Next, saturate the plastic cotton swab in acetone, which you will get at any home repair store. Squeeze the cotton swab made by the screwdriver or butter knife and wash both the bottom side of the bendy laminate as well as the surface it attaches to, known as the substrate. If the unfastened portion is at the end of the counter, a cotton ball will be unchallenging to use. Detach as much adhesive as you can and make it to air dry.
- Rub the contact cement onto the air-dried surfaces in order to build a white film. Rub it on both surfaces and make it to dry partly. It will experience adhesive or wet to the touch.
- Commence from the section of countertop that is still perfectly glued, and smoothly push or spin the laminate down toward the closest edge to get rid of any air bubbles or gaps between the surfaces.
- Position a thicker towel over the counter and put the weight over the top of it. Keep it as it is for nearly 16 to 24 hours unless & until the contact cement dries wholly.
- Finally, take away the towel and examine the countertop to get satisfied as it adhered properly. If not, the second implementation of contact cement may be required. Clean off any leftover adhesive with a cotton ball or old rag immersed in acetone. Cleanse off any acetone with water, and allow it to completely air dry.