How To Fix Over-Sanded Wood: Simple & Easy Procedure To Fix Over-Sanded Wood

Simple & Easy Procedure To Fix Over-sanded Wood

The main reason for the Wood to become distorted or uneven is that if it has been sanded enthusiastically in a single spot. It normally occurs due to the fact that you are trying to sand out discoloration, a spot, defects, groove, hole, indentation, or a scratch. Paying your full attention or efforts on one spot brings into existence an unwanted divot or dip in the wood. This will happen gradually that you will not be able to notice as long as it's too late. If your wood has become over-sanded, then you don't need to worry as it can be restored back to flush by putting some effort with the help of the same sanding block that got you into difficulty in the first place.

Highlight The Problem

Writing or drawing carelessly on the over-sanded area with the help of a pencil will help defects project from a surface. Marks should be made in a generous manner through the problem area and enlarge well past the defect. Defects may not be visible at all at first, however, as soon as sanding begins, the pencil spots inside the defects remain while the pencil spots on the remaining of the wood will vanish. This is one of the best methods that woodworkers have been using for so many years.

Sanding

Start sanding over-sanded wood with the help of a hand block having 100-grit sandpaper, which is a good starting point in order to make the repair. Short, insubstantial & thin strokes parallel to the grain are most successful in producing a desired or intended result. Immediately after noticing that the pencil marks begin to vanish, stop sanding. Make sure to sand parallel to the grain, due to the reason that sanding through grain patterns, can damage the wood forever that may not be fixable. An average amount of pressure may be required in order to sand off the pencil marks, however, the hand block should not be forced into the variations or dips in the over-sanded area. You should keep the block as flat as you possibly can.

Level It

After sanding the wood, it is highly possible that the sanding dust will be present on the surface. A clear perspective or sight of the surface is extremely important. You can use a soft cloth or an air hose in order to get rid of any remaining dust or debris. The pencil spots inside dips and variations where the wood has been over-sanded will still be visible, however, the spots on the flat surface will disappear. This will give you a better understanding of how far the damage extends, as well as the depth of the over-sanded area. The process can be repeated as long as the surface of the wood is level.

Veneer

Wood veneer needs special care, as its depth is only a few centimeters and is easy to sand throughout, bringing into existence a worse problem compared to the original over sanding. A noticeable line on the side of the wood is an indication of a veneer. If in case the wood doesn't have an exposed edge, then you need to assume that it is a veneer. If the grain pattern starts to vanish while sanding, this is an indication to stop instantly. If you go beyond the grain, then it will make a hole in the veneer, which can be touched up with a wood-stain marker, however, this is less than ideal.