Easy Solutions Of Fixing Bed Slats That Keep Falling
One of the main drawbacks of some of the beds is falling slats. Once a slat falls, then it allows the mattress to sink-in, which leads to discomfort for the user. Keeping the slats in the exact place can be a little difficult, but there are ways of keeping the slats in place. Below you will find some of the easy solutions for fixing bed slats that keep falling:
- The first solution to the problem is to check the small, white pin which is supposed to go on the top as well as the bottom of each slat. These pins can easily fall out, and if this happens, the bed slats will also fall out. So it is a good option to check the pins on a regular basis.
- There are some other things which can be done like using the Velcro. To use this add a thin strip all along the ledge at the point where the slats rest. After using this the user can move the bed and there will be no problems with the slats. The Velcro can come either as a self-stick or it may need some sort of the glue both types are good. The user can use the super glue as it is regarded as one of the strongest glues that is available in the market.
- Another suggestion is to add the screws. The user can use this tip for the wooden bed models, as well as can also use the metal screws on models made out of metal. Where to place the screws depends on the size of the bed. For twin beds, it is easy. Simply place a screw in every slat. For the larger beds, especially the bed having a middle rest for the slats, more screws will be required. It is important not to forget to screw on both sides of the slats, left as well as right. The larger beds also require a screw for every slat. It is also very important to use the right type of screw according to the frame type. Like the wooden beds need a screw that must be tapered at the top whereas a metal screw is flat at the top. Also, use the right screwdriver, a flat screwdriver is best for the flat screws.
- The other best solution, is to purchase a sheet of the plywood then cut to the dimensions of the bed as this will also resolve the problem. Also, it is important to remember that the thicker the plywood, the better it is.
- The last solution needs a bit of weaving. Simply take some of the webbing or the other strong ribbon and then weave it all over as well as under the slats.