Proper Procedure Of Finding Floor Joists In Ceiling
Ceiling joists are normally installed either 16 or 24 inches on center, which in turn means nearly 16 or 24 inches apart. As soon as you have located the first one, the others are extremely easy to find. If you only need to know which direction the joists run, approach the attic and take a look. However, if you need to know the exact position of each joist, there are very few options. The two important things that you will need while finding joists in the ceiling include a tape measure & an electronic stud finder.
- First of all, position the end of a tape measure in opposition to the corner created where the wall combines or links the ceiling. Enlarge or stretch the tape measure out 16 inches.
- Tap the ceiling gently, delicately, or softly with the help of your knuckles. You are trying to distinguish the hollow sound that strongly suggests a bay (or space) betwixt two ceiling joists from the solid sound made when your knuckle knocks on the spot where a joist is located.
- You may need to tap numerous inches on one of the sides of the 16-inch mark before finding the joist. If in case you have a stud finder, you can use it rather than making sound comparisons. Stud finders feel changes in density as they project a joist location.
- Enlarge or stretch the tape measure out 24 inches if in case you did not locate a joist 16 inches from the wall/ceiling corner.
- With the help of the tape measure, map the rough location of the next joist, approximately 16 or 24 inches away from the first, and tap the ceiling with the help of your knuckles or sweep a stud finder over the area in order to find or identify the joist’s location. Continue the same process for any other joists you need to locate.
Useful Tip
Electronic stud finders be a sign of or strongly suggests the presence of joists and wall studs by brightening light or signaling with a tone as soon as the wall density increases. The majority of the wall studs also have an adjustment wheel on them that permits you to set the density for your wall. Move the stud finder steadily in one direction, then the other, as long as you have located the joist.