Easy Step By Step Process Of Cutting A 45-degree Angle On Crown Molding
Although it's not tough, it can be tricky to get the corner miters on crown molding just so. In general, two 45-degree cuts are required to create a corner's 90-degree angle; however, you must ensure that the cuts are made on the proper ends of the wood and in the proper directions. Cutting the corner angles first, then measuring and cutting the other ends of the trim to suit the walls, is one technique to make things simpler. By doing so, you can focus on making sure your angles are correct without thinking about whether your length is appropriate.
Things You'll Need
- Tape Measure
- Pencil
- Power Miter Saw
Step By Step Process
- Determine The Lengths Of The Two Walls
In order to determine the lengths of the two walls, you need to measure in both directions from the exterior corner. Select two trim pieces that are a minimum of one foot longer in comparison to the lengths you need. - Use Your Saw & Place The Component
When using your saw, place the component for the left wall on the right side of the blade (looking at the saw from the front). Place the piece face-up with the top edge facing you and the bottom edge facing the saw's guide fence. - Set Your Miter Angle At 45 Degrees To Your Left
The front edge of the saw should be pointed away from the molding that is positioned to the right of the blade when your miter angle is set at 45 degrees to the left. Make the cut close to the board's end while holding the piece in place. - Cut The Angle For The Appropriate Piece
By flipping the arrangement, you can easily cut the angle for the appropriate piece. Place the component on the blade's left side, again, it is important to keep in mind that the bottom edge of the trim is facing the guide fence and the top edge is facing you. Turn the miter setting rightward at 45 degrees. Make the incision close to the piece's end. - Continue Measuring As Well As Cutting
In order to fit the other ends of the pieces on their walls, continue measuring as well as cutting. Make sure you measure from inside the shortest area of the cut on the back as well as the bottom of the trim when you move the measurement from the wall to the molding.
Important Tip To Remember
- Everything is the same for inside corners, with the exception that the miter angles will point in the opposite directions as shown here (toward the trim, rather than away from it). Additionally, inner corners frequently need some of the molding from the miter cut back with a coping saw in order to fit properly because they are likely to have a slight variance in the 90-degree angle.