Easiest Way Of Building A Nightstand With A Drawer
An outstanding nightstand with a drawer is perfect for any bedroom. In addition, any beginner who is performing this task for the first time can build a nightstand with a drawer if the right plans, as well as carpentry techniques, are used. The user can adjust the size of the nightstand according to the needs but should use the same methods shown below to assemble the components:
- Build The Sides: The first step is to build the sides of the nightstand. Therefore, build the legs out of lumber. In order to build the side panels of the nightstand, it is advisable to use the trims and plywood or lumber to cut the sides according to the needed size and availability of the space. To cut out the panels, use a circular saw having a fine blade. Add the strong glue to the trims as well as clamp down all the components together and then insert one 1/4 inch screw through the plywood. Lockdown the panel to the legs with the help of pocket holes and one 1/4” inches screws.
- Back Apron: The next step is to build the back apron as well as install it into the place. The user needs to use a couple of trims and the plywood to get this done in a professional manner. It is advisable to place the trims towards the interior, this will support the drawer efficiently. It is very important to level the apron with the help of a spirit level, then secure it to the side components. Drill pocket holes and then insert one 1/4 inch screws, or the user can drill pilot holes through each leg and then drive in 2-inch screws.
- Install The Bottom Supports: The user needs to continue the project by installing the bottom supports, that is made out of lumber. Cut out the supports at the right size according to the need and then fit them into the right place. Level down the supports before the user is going to drill the pocket holes at both the ends and insert the one 1/4” pocket screws.
- Frame Of The Drawer: Using the lumber, glue and one 1/4” inch pocket screws build the frame of the drawer. Cut out all the components at the right needed size before securing them into place. With the help of a spirit level make sure that the components are horizontally correct after that align them at both ends, before inserting the one 1/4 inch pocket screws. Now the user needs to attach the 1×2 rails to the side aprons and then secure it with the glue and one 1/4 inch screws. Also, drill all the pilot holes, to prevent the wood from splitting.
- Build The Bottom Shelf: With the help of lumber build the slats and glue them all together, before attaching to the supports. Sand down the cut edges and then notch the corners of all the ends of slats, before securing them into place. Drill out the pilot holes in the slats, the user needs to countersink their heads and then insert one 1/4 inch pocket screws. Make sure that the ends of the slats are well flush with the supports.
- Building A Drawer: To build the drawer for the nightstand is a straight forward task. The size of the drawer must be slightly smaller as compared to the opening. In this way, the drawer will slide well along the rails. Cut the boards at the right size according to the need and then join them all together with the help of pocket screws and glue. Clampdown all the components together, this will help to have strong joints.
- Build The Top: It is important to make sure the nightstand top overhangs at least 1” inch on all sides of the table. Lockdown all the slats together with the help of pocket screws and glue. Drill pilot holes through the top and then insert 2-inch screws, countersink their head or drill the pocket screws through the aprons and then insert one 1/4 inch screws. To enhance the bond add the glue.