Step By Step Process Of Binding Carpet Edges
Carpet remnants or leftovers are put together from the end of a big roll of carpet. Due to the fact that it is probably not possible that you will look for a small piece of carpet in a particular style as well as color, the carpet manufacturer usually sells these short pieces at a very large or rapid discount. Due to the reason that they are mostly small or odd sizes, they might not be appropriate for use as wall-to-wall carpeting, however, some carpet remnants make exceptional carpeting for a distinctive room where you will not be able to install traditional carpeting. Remnant carpet offers an economical & affordable, stylish and all-round solution when it comes to hard-to-fit carpet areas, particularly, if you are beautifying & embellishing on a dime. In order to give remnant a polished look, take into consideration binding. While carpet stores offer binding, it exaggerates the cost. Carpet crafters have long been binding their own carpets, so you need to visit your nearby craft store and purchase supplies in order to get a finished carpet look without a big investment.
Things You Will Need
- Carpet-Binding Fabric
- Yardstick
- Scissors
- Hot Glue Gun And Hot Glue Sticks
- Cardboard
Step By Step Process
- Purchase Binding Fabric: First of all, you need to purchase a binding fabric color that goes with or complements your remnant, which as a result gives a professional appearance on your wrapped edges.
- Measure The Length Of Your Carpet: Now, calculate & compute the length of your carpet and then trim a piece of binding fabric that will cover the carpet. Add-in your hot glue gun in order to heat up, while you keep on prepping.
- Cut The Edge Using A Small Knife: Next, put down your remnant on a piece of cardboard before cutting the edge with the help of a small knife, in order to get a clean working edge. If you have trouble trimming elegantly & precisely, then you can use a yardstick which will help you get a straight edge.
- Place The Fabric Alongside Your Carpet: After that, place the fabric alongside your carpet. Draw a line of hot glue down half the carpet binding fabric, concluding in the center. Bend the binding fabric over the carpet and press in order to take hold of it in place, allowing it to go after 10 seconds so the glue can dry. Put in the top half of the binding tape just like this.
- Repeat The Same Process On The Second Side: Repeat the process on the second side while the glue dries. Again, trim the carpet in order to get a clean edge, and trim the binding tape to the right length. Align them up, before hot gluing one half of the binding strip at a time to your remnant. Accomplish the other two sides to complete binding your carpet.